User guide

Developers guidelines | AT commands
211 June 2010
<Delivery order> Description
0 UMTS will not provide in-sequence SDU delivery
1 UMTS will provide in-sequence SDU delivery
<Maximum SDU
size>:
<Maximum SDU
size>
Description
Integer Indicates the maximum allowed SDU size in octets
Note: Not all integer values are valid. The general
rule is that the integer will be rounded down to the
nearest valid value.
It is therefore possible to read out a value other
than that given
0–153 0: Default value – subscribed value will be
requested
<SDU error ratio
>:
<SDU error ratio> Description
String Indicates the target value for the fraction of SDUs
lost or detected as erroneous. SDU error ratio is
defined only for conforming traffic. The value is
specified as “mEe”. For example, a target SDU
error ratio of 510-3 would be specified as “5E3”,
AT+CGEQREQ=…,’5E3’,…
<Residual bit error
ratio>:
<Residual bit error
ratio>
Description
String String parameter that indicates the target value for
the undetected bit error ratio in the delivered SDUs.
If no error detection is requested, <Residual bit
error ratio> indicates the bit error ratio in the
delivered SDUs. The value is specified as “mEe”.
For example, a target residual bit error ratio of 510-
3 would be specified as “5E3”,
AT+CGEQREQ=…,’5E3’,…
<Delivery of
erroneous SDUs>:
<Delivery of
erroneous SDUs>
Description
0 No delivery of erroneous SDUs
1 Erroneous SDUs delivered
2 No detection of erroneous SDUs
<Transfer delay>: