User guide

Developers guidelines | AT commands
226 June 2010
AT+CALD Alarm delete
AT+CAPD Postpone or dismiss an alarm (ver. 2)
AT*EDST Ericsson daylight saving time
<recurr> Description
Format:
“<1..7>[,<1..7>[…]]”
For setting an alarm for one or more days in the
week.
The digits 1 to 7 corresponds to the days of the
week, Monday (1), Sunday (7).
Example: The string “1,2,3,4,5” may be used for
setting an alarm for all weekdays
Format: “0” Sets the alarm for all days in the week
<rlength>: Integer. Maximum length of the <recurr> parameter. Maximum value=13.
<silent>: Not supported.
Description: Removes an active alarm.
Execution
command: AT+CALD=<n>
Test command: AT+CALD=? Shows if the command is supported.
Parameter:
<n>: Integer. Identifies an active alarm.
Description: Controls an active alarm by either postponing or dismissing it. If more than
one active alarm occurs, this command influences the last activated alarm.
Execution
command: AT+CAPD=[<sec>]
Test command: AT+CAPD=? Shows if the command is supported.
Test command
response: +CAPD: (list of supported <sec>s)
Parameter:
<sec>:
<sec> Description
0 Dismisses the alarm. Default value
540 Postpones the alarm (snooze) for 540 seconds (9
minutes). This is the only supported value
Description: Sets the daylight saving time hours.
Note: This command affects the MS clock set with the AT+CCLK com-
mand. To avoid confusion, it is recommended that the daylight saving time
(DST) is set with this command before setting the actual local time with
AT+CCLK.