User guide

Developers guidelines | AT commands
230 June 2010
AT*EAPN Active profile rename
AT*EBCA Battery and charging algorithm (ver. 4)
<name_tagx>: String. Profile name tag.
<nlength>: Integer. Maximum length of <name_tagx>.
Description: Sets a new name for the active profile. The number of profiles and the
default names of the profiles are depending on the phone MMI.
Note: The name of the Normal profile (profile index 1) is read-only.
Set command: AT*EAPN=<name_tag>
Read command: AT*EAPN? Read the name of all the routing profiles in the phone.
Read command
response: *EAPN: <index1>,<name_tag1><CR><LF>
[*EAPN: <index2>,<name_tag2><CR><LF>
[...]]
Test command: AT*EAPN=? Shows if the command is supported.
Test command
response: *EAPN: <nlength>
Parameters:
<index>:
<index> Description
Integer Index of profile as defined in AT*EAPS
<name_tag>: String. Name tag for the profile, for example, Home, Office, Meeting
<nlength>: Integer. Maximum length of field <name_tag>.
Description: Tests the charging algorithm in the phone and turn on/off unsolicited signal
result codes ( *EBCA). When turned on the unsolicited result code is given
once per second.
Voltage, current and capacity are physically limited, that is, they are plat-
form dependent.
Note: For batteries without internal intelligence, some of the parameters
listed below might not be available. In these cases the value “0” (zero) will
be returned.
Note: Compared to earlier versions of this command, the name of the
parameter <remcapacity> has been changed to <remcapacitypercent>
because there is a new parameter showing the remaining capacity in mAh.
This new parameter gets the same name as the old remaining capacity
parameter, <remcapacity>.
Execution
command:
AT*EBCA=<onoff>
Execution command
response: *EBCA: <vbat>,<dcio>,<icharge>,<iphone>,<tempbattery>,<tempphone>,
<chargingmethod>,<chargestate>, <remainingcapacity>,<remcapacity>,
<powerdissipation>,<noccycles>, <nosostimer>,<suspensioncause>
Read command: AT*EBCA? Displays the current <onoff> setting.