User guide

Developers guidelines | AT commands
248 June 2010
AT*EIAPSSW Internet account configuration, write secondary PDP context
parameters
<data_compr> Description
0 No. Default value
1 Yes.
Using default V42 bis parameters for dictionary
size. Negotiates compression in both directions, Rx
and Tx
Description: Specifies secondary PDP context specific parameters of one (or all) sec-
ondary PS bearer Internet accounts.
If <index> in the command refers to a primary account, it will be converted
to a secondary one. Incidentally, this is the way to create a secondary
account when using EIA commands, otherwise AT+CGDSCONT need to
be used. The command does not create an account if it does not already
exist as a primary or secondary account.
This command is used to define the most relevant secondary PDP context
connection parameters.
Note: All secondary PS parameters of this command can also be config-
ured using the normal (Ensemble 15) GPRS commands.
Note: For PS bearers, the <index> maps to the <cid> and <p-index> maps
to <p-cid> used in the GPRS commands.
Note: If the user does not specify an index, the command results in an
error.
Execution
command: AT*EIAPSSW=
<index>,<p-index>[,<traffic_class>][,[header_compr>][,[data_compr>]]]]]
Test command: AT*EIAPSSW=? Test if command is supported and show supported
parameters
Test command
response: Range of Secondary PDP context parameters:
*EIAPSSW: (1-255),(1-255) (0-4),(0-1),(0-1)
Parameter:
<index>:
<index> Description
1–255 Index of the Secondary PDP context for which
Internet account parameters are written.
<index> is a local context identification parameter
<p-index>: