User guide

Developers guidelines | AT commands
263 June 2010
AT*EIAIPCPW Internet account configuration, write PPP parameters – IPCP
<allowed_ncp> Description
0 Not supported
1 01
Network Control Protocol IPCP allowed.
Default value
2 10
Network Control Protocol IPv6CP allowed
3 11
Both network control protocols allowed
Description: Specifies the PPP IPCP parameters of one (or all) Internet accounts.
The command is used to specify the IP addresses to be used, both under
PPP negotiations as well as under PS network connection establishment
(context activation). If “0” values are given, necessary parameters are
requested to be generated dynamically by the network to be attached to. If
specific values are set, static IP addresses are to be requested.
Note: Values stored here are not the ones used when doing PS dial-up
connection from external application (TE), since TE in this case has its own
IP addresses to negotiate with the network (what TE sends is forwarded by
the ME PPP proxy to network).
Note: If the user does not specify both parameters <index> and
<bearer_type>, the command results in an error response.
Note: PPP parameters are relevant for all bearer types, but mostly for
internal calls.
Execution
command: AT*EIAIPCPW=<index>,<bearer_type>[,[<
ip_addr>][,[<prim_dns_addr>][,[<sec_dns_addr>][,[<header_compr>]]]]]
Test command: AT*EIAIPCPW=? Test if command is supported and show supported
parameters
Test command
response: Range of PPP IPCP parameters:
*EIAIPCPW: (1-255)(1-4),(““),(““),(““),(0-1)
Parameter:
<index>:
<index> Description
1–255 Write IPCP parameters of <bearer_type> Internet
Account with index as specified.
For range and more details on <index>, see com-
mand AT*EIAC
<bearer_type>:
<bearer_type> Description
1 PS bearer, that is, PS connection over UMTS/GPRS
network