User guide

Developers guidelines | AT commands
264 June 2010
AT*EIAIPCPR Internet account configuration, read PPP parameters – IPCP
2 CS bearer, NTCSD connection over UMTS/GSM
network
3 Bluetooth bearer, to connect with remote Bluetooth
LAN device
4 External interface, test value, for dial-in use
<ip_addr>:
<ip_addr> Description
String of format
“a.b.c.d”
IPv4 host address.
ME's own IP address. Default set to 0.0.0.0, which
means request for dynamic IP address to be
allocated by network upon connection
<prim_dns_addr>:
<prim_dns_addr> Description
String of format
“a.b.c.d”
IPv4 primary DNS server address.
Default set to 0.0.0.0, which means request for
dynamic IP address to be allocated by network
upon connection
<sec_dns_addr>:
<sec_dns_addr> Description
String of format
“a.b.c.d”
IPv4 secondary DNS server address.
Default set to 0.0.0.0, which means request for
dynamic IP address to be allocated by network
upon connection
<header_compr>:
<header_compr> Description
0 Header compression off. Default value
1 Header compression on
Description: Reads the PPP IPCP parameters of one (or all) Internet account(s).
Note: When <index>=0 it is necessary that <bearer_type>=0 and vice
versa.
Execution
command: AT*EIAIPCPR=[<index>,<bearer_type>]
Response: List of Internet accounts with PPP IPCP parameters:
*EIAIPCPR: <index>,<bearer_type>,<ip_addr>,<prim_DNS_addr>,
<sec_dns_addr>,<header_compr>[:]
Test command: AT*EIAIPCPR=? Test if command is supported and show supported
parameters
<bearer_type> Description