User guide

Developers guidelines | AT commands
272 June 2010
Ensemble S35: Sony Ericsson
commands
Commands
AT*SEACC Accessory class report
<destination_address>:
<destination_
address>
Description
String of format
“a.b.c.d”
IPv4 address of the destination host.
An entry with a value of 0.0.0.0 is considered as the
default route
“x:x:x:x:x:x:x:x” IPv6 address of the destination host.
Each “x” is the hexadecimal values for one of the
eight 16bit pieces of the address. An entry with a
value of :: is considered as the default route
<nexthop_address>:
<nexthop_address> Description
String of format
“a1.a2.a3.a4”
IPv4 address of the adjacent host or router to which
the packet should be sent next.
Not utilised for point-to-point connections
String of format
“x:x:x:x:x:x:x:x”
IPv6 address of the adjacent host or router to which
the packet should be sent next.
Each “x” is the hexadecimal values for one of the
eight 16bit pieces of the address.
Not utilised for point-to-point connections
Description: Informs the MS about the attachment of an accessory at its downstream
port. The command reports the measured value according to the resistive
identification mechanism. The value is the 8 bit number produced by the
A/D converter. It is the responsibility of the MS to interpret this value as an
accessory category.
Execution
command: AT*SEACC=<rid_value>
Report resistive ID value.
Test command: AT*SEACC=?
Test if command is supported and show supported parameters.
Test command
response: *SEACC:(range of supported <rid_value>s)