User guide

Developers guidelines | AT commands
277 June 2010
AT*SECHA Charging control
AT*SELOG SE read log
8000–8999 BTBTLC – A Bluetooth audio device supporting the
Headset or the Handsfree profile and the Advanced
Audio Distribution Profile for installation in car
9000–9999 DSS – Desk Speaker Stand
10000–10999 BDSS – Budget Desk Speaker Stand
11000–11999 LO – Line out accessory
12000–12999 LI – Line in accessory
Description: This command is used by the accessory to tell the phone to pause the
charging of the battery. During the pause the accessory will perform the
measurement according to the AID mechanism to identify the new acces-
sory attached.
If charging is not switched on again the charging pause will end and the
charging resume anyway.
Execution
command: AT*SECHA=<time>
Test command: AT*SECHA=? Test if command is supported and show supported
parameters
Test command
response: *SECHA: (range of supported <time>s)
Parameter:
<time>:
<time> Charging mode
0 Charging resumed. Default value
1–5000 Charging will be paused for the number of
miliseconds stated in this parameter
Description: Reads the customisation log file placed in tpa/preset/log.txt
The result is encoded into a hexadecimal representation.
Execution
command: AT*SELOG
Command
responses: *SELOG:[<data>]
SELOG:<ecode>,<nr_of_bytes>
Test command: AT*SELOG=? Shows if the command is supported
Parameters:
<data>:
<audio_id> Description