User guide

Developers guidelines | AT commands
310 June 2010
Updated AT commands
Ensemble S35: Sony Ericsson commands
Command
AT*SEAUDIO Accessory class report
Description: Informs the phone about the general audio class and the unique audio ID
of an accessory. If there is a specific audio settings container available for
the unique id, the phone will use that configuration. If not, the configuration
for the general audio class will be used.
When the accessory identifies itself acoustically with AT*SEAUDIO the
phone responds with a result code indicating what audio class and what
unique audio ID have been used when configuring audio. If no specific
audio configuration was available for the unique audio ID used by the
accessory this is indicated by setting <unique_audio_id>=0 in the result
code. If the accessory for some reason do not have audiocapabilities it will
send AT*SEAUDIO=0,0.
Execution
command: AT*SEAUDIO=<audio_class>,<unique_audio_id>
Execution command
response *SEAUDIO:<audio_class>,<unique_audio_id>
Read command: AT*SEAUDIO? Read current setting
Test command: AT*SEAUDIO=? Test if command is supported and show supported
parameters
Test command
response: *SEAUDIO:(range of supported <audio_class>s),(range of supported
<unique_audio_id>s)
Parameters:
<audio_class>:
<audio_class> Description
0–255 The default audio class of the accessory
0 The accessory has no audio capabilities
1 PHF – Portable Handsfree
2 VHF – Vehicle Handsfree
3 BVHF – Budget Vehicle Handsfree (without
accessory mic)
4 BT – Bluetooth headset or handsfree
5 BTC – Bluetooth handsfree for installation in Car
6 BTL – Bluetooth Leisure (BT headset supporting the
Advanced Audio Distribution Profile)