User guide

Developers guidelines | AT commands
45 June 2010
ATS7 Completion connection timeout
ATS10 Automatic disconnect delay control
<value> Description
0–127 Supported values
8 Editing character = <BS> (Backspace). Default
value
Description: Defines the maximum time allowed between completion of dialling and the
connection being established. If this time is exceeded, the connection is
aborted.
Set command: ATS7=[<tmo>]
Read command: ATS7? Displays the current <tmo> setting.
Test command: ATS7=? Shows if the command is supported.
Test command
response: S7: (list of supported <tmo>s)
Parameter:
<tmo>:
<tmo> Description
1–255 Possible timeout values in seconds
50 Timeout value in seconds. Default value
Description: Specifies the amount of time the DCE will remain connected to the line
after the absence of received line signal.
Note: For mobile phones this is not applicable and the command is
ignored by the TE. This command is included for compatibility reasons
only.
Set command: ATS10=[<value>]
Read command: ATS10? Displays the current <value> setting.
Test command: ATS10=? Shows if the command is supported.
Test command
response: S10: (list of supported <value>s)
Parameter:
<value>:
<value> Description
1–254 Delay, specified in tenths of a second
2 Remains connected for two tenths of a second.
Default value