Installation guide

wmRmNGTO POWER SUPPLY

/_ WARNING:

Turn off power circuit at the service panel before wiring this unit.

120 VAC, 15 Amp circuit required.

1. Remove j-box cover as shown in Fig. 14.

2. Remove the knockout and install[ the strain reHief (conduit) connector (1/2") in junction box.

3. Run 3 wires; bHack,white and green (#14 AWG) in 1/2" conduit from service pane[ to junction box.

4. Connect bHackwire from service pane[ to bHackor red in junction box, white to white and green

to green-yeHHow. See Fig. 14.

5. CHosejunction box cover.

6. Hug cane at the top of the hood into the junction box connector.

7. Check all[ Hight buHbs to make sure they are secure in their sockets, then turn power on in service

pane[ and check [ights and bHower operation per Care & Use manua[ and install[ drip tray support

and riflers.

1/2 '+

Conduit

Junction

[Box

From Control

Panel

FIG. 14