Installation Guide
12
4. If you are installing your keg refrigerator under a
counter you will need to drill 5 holes in the counter top
to mount the tower. The rst hole is a 1
1
⁄2" diameter
hole located at the center of the tower for the beer
line, locate approximately 13
1
⁄2" (34.3 cm) from the
front edge of the counter top (based on a counter top
depth of 25
5
⁄16"). Next drill the 4 tower mounting holes
per the dimensions in Figure 23. The hole diameter
is dependent on the counter top material and if screw
anchors are required. The screws supplied are in the
literature pack and are a #10 x 1" type AB stainless
steel screw. Mark and cut the rectangular cutout for
the drain sump. After the holes are drilled and the
keg refrigerator is in place under the counter top feed
the beer line through the tower gasket, the 1
1
⁄2" hole
in the counter top and the hole in the top of the keg
refrigerator. Mount the tower to the counter top with the
4 screws provided. Place the counter top drain sump,
from the literature pack, in the rectangular hole with the
radius cutout to the rear around the tower and place
the grate in the sump.
5. Mount the regulator to the CO
2 tank (connection
B
)
use the new plastic washer you received from the gas
supply company. Note that the regulator has left hand
threads and has to be turned counterclockwise to
tighten. Tighten with the adjustable wrench or the 1
1
⁄8"
open end wrench.
6. Connect the red air line(s) from the regulator to the
large air line tting on the keg coupler with a large
hose clamp (connection
C
).
7. Connect the clear beer line from the tower to the small
air line tting on the keg coupler with a small hose
clamp (connection
A
).
Figure 23
Figure 24
Figure 25
Tower
!
CAUTION
The cutout dimensions shown in Figure 23 are based on
a 25
5
⁄16" (64.3 cm) deep counter top. Your counter top may
be different than this and require other front to back dimen-
sioning. Refer to the product dimensions on page 8 when
determining the required dimensions.
Grate from top of
beer dispenser
Counter top
sump from
literature pack
Rear of counter top
1
3
⁄8"
(3.5 cm)
typical
1
1
⁄2" (38 mm)
Diameter
2
7
⁄38"
(7.3 cm)
4
1
⁄4"
(10.8 cm)
6
3
⁄8"
(16.2 cm)
1
⁄4" (6 mm)
radii,
typical
12
1
⁄4"
(31.1 cm)
6
1
⁄8"
(15.6 cm)
counter
top depth
25
5
⁄16"
(64.3 cm)
Diameter
to suit
US
CA
USING YOUR BEER DISPENSER