Installation Guide

Figure 27

Figure 27a

Rotate the top of the coupler coun-

ter clockwise to extend the coupler

to the to the "OFF"position.

Coupler

extended

8. Locate the CO

2 tank in the corner of the refrigerator as

shown in Figure 26 and secure with the chain. Close

the faucet handle on the tower.

9. Hooking up the keg coupler to the keg: Verify the cou-

pler is in the "OFF" position (see Figure 27a).Align the

lugs on the keg with the corresponding openings on the

keg coupler and turn clockwise until the coupler stops

(about 90°). Push down and twist the top of the coupler

clockwise to allow gas to enter the keg.

Figure 26

Chain-The chain is fastened

and taped to the top of the

interior liner. Remove the tape

and secure the CO

2 tank in

place in the back right corner.

Loop chain around top of tank

and connect with "S" hook.

Push faucet handle back toward

tower to close the faucet

Figure 26a

Connect with

"S" hook

USING YOUR BEER DISPENSER

Lugs

on keg

Figure 27b