Activesmart Built-in 80/84in Installation Guide Flush Inset - Framed

ManualsBrandsDCS ManualsAppliancesActiveSmart Series 36 Inch Built In Counter Depth French Door Refrigerator, in Panel Ready

!3 ASSEMBLE DOOR PANEL SET

The assembly of DCS by Fisher & Paykel kits (Stainless steel door panels) and custom door panels are outlined below. For DCS by Fisher & Paykel kits, only remove the protective film for handle

installation. This will protect the finish of the door panels until installation is complete.

1 Mounting handle (refer to A)

For DCS by Fisher & Paykel door panel

sets, remove the plastic plugs from the

handle holes x4. Align the handle to the

holes and secure with screw handle x4

(M5x 25 pan head socket screws).

For custom panels, ensure handle is

secured 2⁄” (65 mm) from the inner edge

of the panel to the center – this will avoid

interference with bracket installation.

2 Hanging bracket (refer to B)

For DCS by Fisher & Paykel door panel sets,

align the bracket to the holes and secure

with screws x4 (M5 x 14 Mush Phillips SS).

For custom panels, secure bracket with

screws x4 (#8 x 16 Mush washer screws).

3 Side brackets and straps (refer to C)

For DCS by Fisher & Paykel

door panel sets, align

bracket and strap to the

holes on the side of the

panel and secure with

screws x2 (M5 x 14

Mush Phillips SS).

For custom panels,

secure bracket with

screws x2 (#8 x 16

Mush washer screws).

Repeat this process for

all brackets and straps, and

remaining French door panel.

French door panels Drawer door panel

4 Mounting handle (refer to D)

For DCS by Fisher & Paykel door panel

sets, remove the plastic plugs from the

handle holes x4. Align the handle to the

holes and secure with screw handle x4

(M5 x 25 pan head socket screws).

For custom panels, ensure handle screw

heads are counter sunk into the back

of the panel to avoid interference with

hanging bracket.

5 Hanging bracket (refer to E)

For DCS by Fisher & Paykel door panel

sets, align the bracket to the holes and

secure with screws x6 (M5 x 14 Mush

Phillips SS).

For custom panels, secure bracket with

screws x6 (#8 x 16 Mush washer screws).

6 Side brackets and straps (refer to F)

For DCS by Fisher & Paykel door

panel sets, align bracket and strap to

the holes on the side of the panel and

secure with screws x2 (M5 x 14 Mush

Phillips SS).

For custom panels, secure bracket

with screws x2 (#8 x 16 Mush washer

screws).

Repeat this process for all brackets

and straps.