user guide

13
CARE AND CLEANING
Stainless steel
Always use the mildest cleaning method first. Do not use steel wool to clean the product as
it will scratch the surface.
Burner grates
For durability and optimal performance, the side burner grates are crafted using porcelain
enamel over cast iron. It is recommended that the grates are cleaned while in place,
however if removing the grates take care as they are heavy and ensure they are placed on a
protected surface. Grates can be cleaned using hot soapy water.
Due to rapid temperature changes the porcelain may lift from the edges of the grates. If the
grates develop chips do not be concerned, over time the cast iron will darken to blend with
the enamel. When wiping areas where the enamel has lifted take care as the edges may be
sharp.
Drip tray
To clean the drip tray, pull tray forward to remove. Wipe spills as soon as possible to
prevent them becoming baked on.
Cleaning burner parts
1 Ensure all burner dials are in the
OFF
position and all surfaces are cool.
2 Remove the burner cap and port ring
and wash in hot soapy water, rinse and
dry. The burner ports can be cleaned
using a bristled brush if needed.
3 After cleaning, ensure the locating
pins are correctly aligned. Incorrect
alignment can cause poor burner
performance and dangerous flames.
Refer to page 11 for more detail.
Cap
Port ring
Locating
notch
Base
Ignitor
Locating pins
Locating holes