Owners Guide

Fig. 7

REMOVING DRAWERS

1. Once the unit has been inspected, remove the drawers by pulling them out until their slider latch is visible. Carefully push the

latch down on the left side while pulling up on the right side and pull the drawers completely out of the frame (Fig. 7).

2. To prevent damage to surfaces, place the drawers on a stable surface on a protective towel or table cloth.

TO REMOVE THE ADR224 DRAWER, pull the drawer out and lift the end by the handle to disengage the rollers (Fig. 8).

SLIDE IN FRAME AND MOUNT TO SUPPORT STRUCTURE

1. With the help of an assistant, lift the unit and slide it into the cabinet cutout. Adjust for level and fit.

2. Locate mounting holes on the frame (Fig. 9 and views). Secure the unit using screws suited for the type of cabinet material.

NOTE: Depending on the wall thickness and location of mounting holes, an additional board may be required to properly

receive the screws.

Fig. 9

Slider latch

11-3/4"

4-1/8"

1 - 5/16"

3-9/16"

(

1/4" )

Anchor hole

15/16"

Fig. 8

LIFT

INSTALLATION