Owners Guide

13
The Access Drawers are made from corrosion-resistant and non-magnetic stainless steel. All parts of the Access Drawers
can be cleaned with hot soapy water, rinsed, dried and buffed to a shine with a soft, heavy cloth. Always try this first, as it is
the mildest cleaning procedure. There are many different stainless steel cleaners available. Always use the mildest cleaning
procedure first, scrubbing in the direction of the grain to avoid marring the surface The cleaner will be more effective when
used in the direction of the grain (polish lines).
1. Some brands of cleaners of the same type are harsher than others, read their directions. A scent or a propellant can make a
difference in the product, read the ingredients. Try on a small area first.
2. To touch up noticeable scratches in the stainless steel, sand very lightly with wet 100 grit emery paper in the direction of the
grain.
3. Specks of grease can gather on the surfaces of the stainless steel and bake on to the surface and give the appearance of rust.
For removal use an abrasive pad (Scotch Brite is good) in conjunction with a stain-
less steel cleaner. Always rub in the direction of the grain.
4. Use only clean sponges, soft cloths, paper towels, plastic non-metal soap pads for
cleaning or scouring as recommended in this section. (Use only soap pads with
soap still in them. An empty pad can scratch.)
5. Be sure to rinse all parts thoroughly and to wipe dry to avoid water marks.
NOTE: Stainless steel tends to corrode in presence of chlorides and
sulfides especially in coastal areas. To ensure corrosion prevention, wash
all stainless steel surfaces every 3-4 weeks with fresh water and stainless
cleaner.
BRAND NAME CLEANERS
In this section on cleaning, the use of name brands is intended only to indicate a type of cleaner.
This does not constitute an endorsement. The omission of any name brand cleaner does not imply its adequacy or inade-
quacy. Many products are regional in distribution and can be found in local markets and department stores.
MAINTENANCE
After cleaning, use a stainless steel polish, such as Stainless Steel Magic® applied to the drawer and handle surfaces.
To maintain the smooth operation of the drawers, spray the bearing areas with silicone spray lubricant annually (Fig. 16).
ACCESSORIES
1. Freezer Pack (optional, Kit #70696A)(Fig. 17).
This cold-assist Ice Pack (BLUICE) fits snugly into the
roller rack found on the 30” and 48” Access Drawers and CAD carts.
2. Waste Basket Holder (optional, Kit #70906)(Fig. 18)
3. Bottom Cover (optional, Kit #70907)(Fig. 19)
CARE & MAINTENANCE
Fig. 16
Lubrication
points
(Use
silicone
spray
annually)
Fig. 17 - Freezer Pack (optional)
Fig. 18 - Waste Basket Holder (optional)
Fig. 19 - Bottom Cover
(optional)
NOTE: To order these accessories,
please contact Fisher & Paykel Customer
Care at 1-888-936-7872.