Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 182 of 318
#QTEMP - Query Temperature Overflow
#QTEMP: <temp>
where:
<temp> - over temperature indicator
0 - the device temperature is in the working range
1 - the device temperature is out of the working range
Note: typical
temperature working range is (-10°C..+55°C); anyway you are
strongly recommended to consult the “Hardware User Guide” to verify the
real temperature working range of your module
#QTEMP=? Test command reports supported range of values for parameter <mode>.
Note The device should not be operated out of its working temperature range,
elsewhere proper functioning of the device is not ensured.
3.5.7.1.20. Temperature Monitor - #TEMPMON
#TEMPMON - Temperature Monitor
AT#TEMPMON=
<mod>
[,<urcmode>
[,<action>
[,<hyst_time>
[,<GPIO>]]]]
Set command sets the behaviour of the module internal temperature
monitor.
Parameters:
<mod>
0 - sets the command parameters.
1 - triggers the measurement of the module internal temperature,
reporting the result in the format:
#TEMPMEAS: <level>,<value>
where:
<level> - threshold level
-2 - extreme temperature lower bound (see Note)
-1 - operating temperature lower bound (see Note)
0 - normal temperature
1 - operating temperature upper bound (see Note)
2 - extreme temperature upper bound (see Note)
<value>
actual temperature expressed in Celsius degrees