Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 184 of 318
required only if <action>=4 is enabled.
Note: if the <GPIO> is specified <action> shall assume values from
4-7.
Note: last <urcmode> settings are saved as extended profile
parameters.
Note: last <action>, <hyst_time> and <GPIO> settings are global
parameters saved in NVM
AT#TEMPMON? Read command reports the current parameter settings for
#TEMPMON command in the format:
#TEMPMON: <urcmode>,<action>[,<hyst_time>[,<GPIO>]]
AT#TEMPMON=? Test command reports the supported range of values for parameters
<mod>, <urcmode>, <action>, <hyst_time> and <GPIO>
Note In the following table typical temperature bounds are
represented; anyway you are strongly recommended to consult
the “Hardware User Guide” to verify the real temperature
bounds for your module.
Extreme Temperature Lower Bound
(*)
T
ext_low
Operating Temperature Lower Bound
(*)
T
op_low
Operating Temperature
Operating Temperature Upper Bound
(*)
T
op_up
Extreme Temperature Upper Bound
(*)
T
ext_up
(*)
Due to temperature measurement uncertainty there is a
tolerance of +/-2°C
3.5.7.1.21. General Purpose Input/Output Pin Control - #GPIO
#GPIO - General Purpose Input/Output Pin Control
AT#GPIO=[<pin>,
<mode>[,<dir>]]
Execution command sets the value of the general purpose output pin
GPIO<pin> according to <dir> and <mode> parameter.
Not all configuration for the three parameters are valid.