Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 223 of 318
#SRXAGC – RX AGC Enable
AT#SRXAGC=
<mode>
Set command sets the RX AGC enabling
Parameter:
<mode>
0 - disables rx agc (default)
1 - enables rx agc
Note: RX AGC enabling makes RX level decreasing
Note: these values are automatically saved in NVM.
AT#SRXAGC? Read command returns the current RX AGC values:
#SRXAGC: <mode>
AT#SRXAGC=? Test command returns the supported range of values of parameter
<mode>.
3.5.7.1.75. Handset RX filter coefficients values - #SHSFRX
#SHSFRX - Handset RX filter coefficients values
AT#SHSFRX=
<tap0>,<tap1>,<tap2>,<tap3>,
<tap4>,<tap5>,<tap6>
Set command sets the handset RX filter coefficients values
Parameter:
<tap0>: Filter Tap, h[0] and h[12]
<tap1>: Filter Tap, h[1] and h[11]
<tap2>: Filter Tap, h[2] and h[10]
<tap3>: Filter Tap, h[3] and h[9]
<tap4>: Filter Tap, h[4] and h[8]
<tap5>: Filter Tap, h[5] and h[7]
<tap6>: Filter Tap, h[6]
Note: these values are automatically saved in NVM.
AT#SHSFRX? Read command returns the current handset TX filter coefficients
values:
#SHSFRX: <tap0>,<tap1>,<tap2>,<tap3>,<tap4>,<tap5>,<tap6>
AT#SHSFRX=? Test command returns the supported range of values of parameter
<tap0>,<tap1>,<tap2>,<tap3>,<tap4>,<tap5>,<tap6>.
3.5.7.1.76. Handset TX filter coefficients values - #SHSFTX
#SHSFTX - Handset TX filter coefficients values
AT#SHSFTX= Set command sets the handset TX filter coefficients values