Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 225 of 318
#SHFFTX - Handsfree TX filter coefficients values
AT#SHFFTX=
<tap0>,<tap1>,<tap2>,<tap3>,
<tap4>,<tap5>,<tap6>
Set command sets the handsfree TX filter coefficients values
Parameter:
<tap0>: Filter Tap, h[0] and h[12]
<tap1>: Filter Tap, h[1] and h[11]
<tap2>: Filter Tap, h[2] and h[10]
<tap3>: Filter Tap, h[3] and h[9]
<tap4>: Filter Tap, h[4] and h[8]
<tap5>: Filter Tap, h[5] and h[7]
<tap6>: Filter Tap, h[6]
Note: these values are automatically saved in NVM.
AT#SHFFTX? Read command returns the current handsfree TX filter coefficients
values:
#SHSFTX: <tap0>,<tap1>,<tap2>,<tap3>,<tap4>,<tap5>,<tap6>
AT#SHFFTX=? Test command returns the supported range of values of parameter
<tap0>,<tap1>,<tap2>,<tap3>,<tap4>,<tap5>,<tap6>.
3.5.7.1.79. Repeat Last Command - #/
#/ - Repeat Last Command
AT#/ Execute command is used to execute again the last received command.
3.5.7.1.80. Network Timezone - #NITZ
#NITZ - Network Timezone
AT#NITZ=
[<val>
[,<mode>]]
Set command enables/disables (a) automatic date/time updating, (b) Full
Network Name applying and (c) #NITZ URC; moreover it permits to change
the #NITZ URC format.
Date and time information can be sent by the network after GSM
registration or after GPRS attach.
Parameters:
<val>
0 - disables (a) automatic data/time updating, (b) Full Network Name
applying and (c) #NITZ URC; moreover it sets the #NITZ URC
‘basic’
format (see <datetime> below) (factory default)
1..15 - as a sum of:
1 - enables automatic date/time updating
2 - enables Full Network Name applying