Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 228 of 318
#BND - Select Band
Note: the range of values differs between triband modules and quadric-
band modules
3.5.7.1.82. Automatic Band Selection - #AUTOBND
#AUTOBND - Automatic Band Selection
AT#AUTOBND=
[<value>]
Set command enables/disables the automatic band selection at power-on.
Parameter:
<value>:
0 - disables automatic band selection at
next power-up (factory default)
1 - enables automatic band selection at
next power-up; the automatic
band selection stops as soon as a GSM cell is found.
2 - enables automatic band selection in four bands (at 850/1900 and
900/1800); differently from previous settings it takes
immediate effect
Note: necessary condition to
effectively have automatic band selection at
next power-up (due to either AT#AUTOBND=1 or AT#AUTOBND=2) is that
AT+COPS=0 has to be previously issued
Note: if automatic band selection is enabled the band changes every about
90 seconds through available bands until a GSM cell is found.
Note: Default value for UC864-G AT&T (08.01.127) is 2.
AT#AUTOBND? Read command returns whether the automatic band selection is enabled or
not in the form:
#AUTOBND: <value>
AT#AUTOBND=? Test command returns the range of supported values for parameter
<value>.
Note Customers of UC864-G Telstra (Australia) version are recommended NOT to
use #AUTOBND command because #BND covers the same function.
3.5.7.1.83. Skip Escape Sequence - #SKIPESC
#SKIPESC - Skip Escape Sequence
AT#SKIPESC=
[<mode>]
Set command enables/disables skipping the escape sequence +++ while
transmitting during a data connection.
Parameter: