Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

#PLMNMODE – Apply to New Operator Names

AT#PLMNMODE=? Test command returns supported values of the parameter <mode>.

3.5.7.1.97. Network Scan Timer - #NWSCANTMR

#NWSCANTMR - Network Scan Timer

AT#NWSCANTMR=

<tmr>

Set command sets the Network Scan Timer that is used by the module to

schedule the next network search when it is without network coverage (no

signal).

Parameter:

<tmr> - timer value in units of seconds

5 3600 - time in seconds (default 5 secs.)

AT#NWSCANTMR Execution command reports time, in seconds, when the next scan activity

will be executed. The format is:

#NWSCANTMREXP: <time>

Note: if <time> is zero it means that the timer is not running

AT#NWSCANTMR? Read command reports the current parameter setting for #NWSCANTMR

command in the format:

#NWSCANTMR: <tmr>

AT#NWSCANTMR=? Test command reports the supported range of values for parameter <tmr>

Note This command is not supported in UC864-G AT&T.

How much time it takes to execute the network scan depends either on how

much bands have been selected and on network configuration (mean value

is 5 seconds)

3.5.7.1.98. Network Emergency Number Update - #NWEN

#NWEN - Network Emergency Number Update

AT#NWEN=[<en>] Set command enables/disables URC of emergency number update.

Parameters:

<en>

0 - disables URC of emergency number update (factory default)

1 - enables URC of emergency number update