Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

+COPS - Operator Selection

4 - manual/automatic (<oper> field shall be present); if manual selection

fails, automatic mode (<mode>=0) is entered

0 - alphanumeric long form (max length 16 digits)

1 - short format alphanumeric <oper>

2 - numeric 5 digits [country code (3) + network code (2)]

<oper>: network operator in format defined by <format> parameter.

Note: <mode> parameter setting is stored in NVM and available at next

reboot, if it is not 3 (i.e.: set only <format> parameter).

Note: if <mode>=1 or 4, the selected network is stored in NVM too and is

available at next reboot (this will happen even with a new SIM inserted)

Note: <format> parameter setting is never stored in NVM

<AcT> access technology selected:

0 GSM

2 UTRAN

AT+COPS? Read command returns current value of <mode>,<format> and <oper> in

format <format>; if no operator is selected, <format> and <oper> are

omitted

+COPS: <mode>[,<format>,<oper>,< AcT>]

AT+COPS=? Test command returns a list of quintuplets, each representing an operator

present in the network.

The quintuplets in the list are separated by commas:

+COPS: : [list of supported (<stat>,long alphanumeric <oper>

,short alphanumeric <oper>,numeric <oper>,< AcT>)s]

[,,(list of supported <mode>s),(list of supported <format>s)]

where:

<stat> - operator availability

0 - unknown

1 - available

2 - current

3 - forbidden

<AcT> access technology selected:

0 GSM

2 UTRAN

Note: since with this command a network scan is done, this command may