Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

+CLIP - Calling Line Identification Presentation

set should be the one selected with command Select TE

character set +CSCS.

<CLI_validity>

0 - CLI valid

1 - CLI has been withheld by the originator.

2 - CLI is not available due to interworking problems or limitation or

originating network.

Note: in the +CLIP: response they are currently not reported either the

subaddress information (it’s always “” after the 2

comma) and the

subaddress type information (it’s always 128 after the 3

comma)

AT+CLIP?

Read command returns the presentation status of the CLI in

the format:

+CLIP: <n>,<m>

where:

<n>

0 - CLI presentation disabled

1 - CLI presentation enabled

<m> - status of the CLIP service on the UMTS network

0 - CLIP not provisioned

1 - CLIP provisioned

2 - unknown (e.g. no network is present )

Note: This command issues a status request to the network, hence it may

take a few seconds to give the answer due to the time needed to exchange

data with it.

AT+CLIP=? Test command returns the supported values of parameter <n>

Reference 3GPP TS 27.007

Note The command changes only the report behaviour of the device, it does not

change CLI supplementary service setting on the network.

3.5.4.3.8. Calling Line Identification Restriction - +CLIR

+CLIR - Calling Line Identification Restriction

AT+CLIR=[<n>] Set command overrides the CLIR subscription when temporary mode is

provisioned as a default adjustment for all following outgoing calls. This

adjustment can be revoked by using the opposite command. This command

refers to CLIR-service (3GPP TS 02.81/21.081) that allows a calling

subscriber to enable or disable the presentation of the CLI to the called

party when originating a call.

Parameter: