Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 82 of 318
+CLIR - Calling Line Identification Restriction
<n> - facility status on the Mobile
0 - CLIR facility according to CLIR service network status
1 - CLIR facility active (CLI not sent)
2 - CLIR facility not active (CLI sent)
AT+CLIR? Read command gives the default adjustment for all outgoing calls (<n>) and
also triggers an interrogation of the provision status of the CLIR service
(<m>), where
<n> - facility status on the Mobile
0 - CLIR facility according to CLIR service network status
1 - CLIR facility active (CLI not sent)
2 - CLIR facility not active (CLI sent)
<m> - facility status on the Network
0 - CLIR service not provisioned
1 - CLIR service provisioned permanently
2 - unknown (e.g. no network present, etc.)
3 - CLI temporary mode presentation restricted
4 - CLI temporary mode presentation allowed
AT+CLIR=? Test command reports the supported values of parameter <n>.
Reference 3GPP TS 27.007
Note This command sets the default behaviour of the device in outgoing calls.
3.5.4.3.9. Connected line identification presentation - COLP
+COLP - Connected line identification presentation
AT+COLP=[<n>] Set command enables or disables the presentation of the COL at the TE
Parameter:
<n>
0 – disable (factory default)
1 - enable
Note: When enabled (and called subscriber allows),
+COLP: <number>,<type>[,<subaddr>,<satype> [,<alpha>]] intermediate
result code is returned from TA to TE before any +CR or V.25ter [14]
responses. It is manufacturer specific if this response is used when normal
voice call is established.
AT+COLP? Read command gives the status of <n>, and also triggers an interrogation of
the provision status of the COLP service according 3GPP TS 22.081 [3] (given
in <m>).
+COLP: <n>,<m>
Where,
<n>