Specifications

UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 99 of 318
+CIND - Indicator Control
“message” - message received
<ind> - message received indicator range
0 - there is no unread short message at memory locations
1 - unread short message at memory locations
“call” - call in progress
<ind> - call in progress indicator range
0 - there’s no calls in progress
1 - at least a call has been established
“roam” - roaming
<ind> - roaming indicator range
0 - registered to home network or not registered
1 - registered to other network
“smsfull” - a short message memory storage in the MT has become full
(1), or memory locations are available (0)
<ind> - short message memory storage indicator range
0 - memory locations are available
1 - a short message memory storage in the MT has become full.
“rssi” - received signal (field) strength
<ind> - received signal strength level indicator range
0 - signal strength ≤ (-112) dBm
1..4 - signal strength in 15 dBm steps
5 - signal strength ≥ (-51) dBm
99 - not measurable
Example Next command causes all the indicators to be registered
AT+CIND=1,1,1,1,1,1,1,1,1
Next command causes all the indicators to be de-registered
AT+CIND=0,0,0,0,0,0,0,0,0
Next command to query the current value of all indicators
AT+CIND?
CIND: 4,0,1,0,0,0,0,0,2
OK
Note See command +CMER
Reference 3GPP TS 27.007
3.5.4.4.6. Mobile Equipment Event Reporting - +CMER
+CMER - Mobile Equipment Event Reporting
AT+CMER=
[<mode>
[,<keyp>
[,<disp>
[,<ind>
[,<bfr>]]]]]
Set command enables/disables sending of unsolicited result codes from
TA to TE in the case of indicator state changes (n.b.: sending of URCs in the
case of key pressings or display changes are currently not implemented).
Parameters:
<mode> - controls the processing of unsolicited result codes