Specifications

UC864-E/G/WD/WDU Product Description
80281ST10034a Rev. 4 – 2009-06-24
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 8 of 57
1.4 Document Organization
This document contains the following chapters:
Chapter 1: “Introduction” provides a scope for this document, target audience, contact and
support information, and text conventions.
Chapter 2: “Overview”
gives an overview of the features of the product.
Chapter 3: “General product Description”
describes in details the characteristics of the product,
providing information such as operating frequencies, mechanical dimensions and interfaces
specifics.
Chapter 4: “Evaluation Kit”
provides a brief description of the Telit Evaluation Kit (EVK2)
as far as these modules are concerned.
Chapter 5: “Software Features”
describes in details concepts involved in the software equipped
on the modules.
Chapter 6: “AT Commands”
provides specification of the AT commands supported by the
modules.
Chapter 7: “Conformity Assessment Issues”
provides some fundamental hints about the
conformity assessment that the final application might need.
Chapter 8: “Safety Recommendation”
provides some safety recommendations that must be
followed by the customer in the design of applications that makes use of the modules.
1.5 Text Conventions
Danger – This information MUST be followed or catastrophic equipment failure or
bodily injury may occur.
Caution or Warning – Alerts the user to important points about integrating the
module, if these points are not followed, the module and end user equipment
may fail or malfunction.
Tip or Information – Provides advice and suggestions that may be useful when
integrating the module.
All dates are in ISO 8601 format, i.e. YYYY-MM-DD.