User manual

12
Left Side
DC-In Power Outlet
The Serial to Wi-Fi Converter is powered by a single 12V DC(Inner
positive/outer negative) power supply and 1.0 A of current. A suitable power
supply adapter is part of the packaging. Connect the power line to the power
outlet at the left side of Serial to Wi-Fi Converter and put the adapter into the
socket. If the power is properly supplied, the “SYS” red color LED will be on
after 30 seconds.
Ethernet Port
The connector for network is the usual RJ45. Simply connect it to your
network switch or Hub. When the connection is made, the LAN LED
indicator will light. When data traffic occurs on the network, red (Rx/Tx)
indicator will blink during data transferring and receiving.
Antenna Connector
The connector for antenna is a standard reverse SMA jack. Simply connect it
to a 2.0dBi or 5.0dBi dipole antenna (Standard Rubber Duck) and it is 50
Ohms impedance and can support 2.4GHz frequency.
Ethernet Port
Antenna
DC-In
Power Outlet
Reset Button