User guide

30
2 / INSTALLING YOUR APPLIANCE
EN
fig. 4
fig. 3
D
E
J
— Remove the filter cartridges (J/fig. 4).
— Screw in the two bottom screws (E/fig. 4).
***********************************
FFoorr tthhee DDHHDD112200XXEE mmooddeell oonnllyy::
— Screw in the two additional bottom screws
(K/fig. 4).
***********************************
35 cm
35 cm
fig. 2
F
H
H
***********************************
FFoorr tthhee DDHHDD112200XXEE mmooddeell oonnllyy::
— Draw a horizontal line (F/fig. 2) through the two
previously drilled holes (G).
— Drill the two additional holes (H/fig. 2) located
on the line (F) at a distance of 35 cm from the
initial holes (G).
— Insert the two additional wall plugs.
— Screw in the top two screws for the hood
(D/fig. 1), leaving 5 mm sticking out from the wall.
*****************************************
G
K
K
— Hang the suction hood on the two screws
(fig. 3).
Tip
Before fully tightening the four D and E
screws (or six D, E and K screws depending
on the model), adjust the level of the hood.
99636271_ML_A.qxp 20/06/2005 11:22 Page 30