Operation Manual

15GB
(A)
(B)
Vr
9
16
12c
12d
8
Mounting the hood body
• Open the ducting panels.
• Disconnect the panel from the hood canopy by
sliding the fixing pin lever.(A)
• Remove the metal grease filters by turning the
handles provided.
• Adjust the two screws Vr, on brackets 11a, to a
minimum.(B)
• Hook the hood canopy onto the two brackets 11a.
• From inside the hood canopy, adjust the screws
Vr to set the Hood Canopy level.
• Tighten the safety screw 11.
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid
pipe, the choice of which is left to the installer.
• Insert the flange 9 (optional), on the hood body
outlet.
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
• Remove any activated charcoal filters.
RECIRCULATION VERSION AIR OUTLET
To install the Recirculation Version of the hood, the optional Activated charcoal cartridge kit must be
purchased.
• Screw the filter cover onto the air outlet, using
four screws 12c (2.9 x 12.5).
• Fix the directional grille 8 on the recirculation air
outlet using the 2 screws 12d (2,9 x 9,5) provided.