Operation Manual

26
2 / USING YOUR APPLIANCE
EN
•
How to set the time
--
When supplied with electricity
The display flashes at 12:00 (fig.1).
Set the time by pressing the + or - touch
controls (holding your finger on the touch
control allows you to scroll through the
numbers rapidly) (fig.2).
Example : 12:30
Press the button to confirm.
The time display no longer flashes (fig.3).
fig.1
fig.2
fig.2
fig.3
fig.1
- To reset the time on the clock
Press and hold the button for a few
seconds until the display starts flashing
(fig.1), then release.
Audible beeps indicate that it is now possible
to set the time.
Adjust the time with the + and - buttons
(fig.2).
Press the button to confirm.
Warning
If there is no confirmation from the
“
” button, the set time will not be confir-
med and the time will revert to the time be-
fore setting.
99644001_A_ml.qxp 21/12/2007 10:36 Page 26