Operation Manual

48
EN 7 / ADJUSTING THE SETTINGS
• SETTINGS POSSIBLE USING THE “SET” FUNCTION
AND THE + / - SELECTION BUTTONS:
- You can access the settings menu by pressing the
"SET" function's 2 buttons
X
at length.
- Then, briefly pressing one of the same buttons
X
allows you to run through the various settings.
- Adjust your settings by pressing the +/- selection but-
tons
- You will leave the settings menu after 10 seconds or by
pressing “START“ .
Choosing the language
Once you have entered the settings menu, press the
++
or
--
button to select the language you require.
Setting the clock (hour)
As above; press the
++//--
buttons until the required
hour is displayed.
Press one of the buttons
X
to validate the hour and
then set the minutes.
Setting the clock (minutes)
As above; press the
++//--
buttons until the correct
number of minutes is displayed.
Adjusting the softener settings
Set according to the corresponding degree of hard-
ness measured, from
H0
to
H6
.
44
33
22
11
X
Press the
buttons once
at length
press selection buttons
press or
1100 sseecc..
OOrr
88
<<< ENGLISH
>>>