User manual

10
MANUTENCIÓN
Desenchufar siempre el aparato antes de
proceder a cualquier operación de limpieza.
Atención
Este aparato contiene hidrocarburos en el circuito
refrigerante; por lo tanto el mantenimiento y la
recarga deben ser efectuados exclusivamente por
personal autorizado por la empresa.
Temporadas largas de inactividad
Durante los períodos en los cuales el aparato no
esté funcionando observar las siguientes
precauciones:
desenchufarlo;
sacar todos los alimentos;
limpiar cuidadosamente el interior y todos los
accesorios.
Dejar las puertas entornadas para facilitar la
circulación del aire, a fin de evitar la formación de
olores desagradables.
Limpieza periódica
Lavar el interior con agua tibia y bicarbonato sódico.
Enjuagar y secar cuidadosamente.
Limpiar el condensador y el motocompresor con un
cepillo o un aspirador. Esta operación mejorará el
funcionamiento con el consiguiente ahorro de
energia.
Lámpara de iluminación
Se puede acceder a la lámpara de iluminación del
compartimento refrigerante efectuando las
siguientes operaciones:
desatornillar el tornillo de fijación del
cubrelámpara,
desenganchar la parte móvil como se indica en la
Si con la puerta abierta la luz no se enciende,
controlar que esté bien enroscada; si el defecto no
se corrige, cambiar la bombilla con otra de igual
potencia.
La potencia máxima se indica en el difusor
D411
Desecarche
La escarcha del evaporador del compartimento
refrigerante se elimina automáticamente a cada
interrupcion del motocompresor. El agua de la
escarcha derretida, mediante un canal adecuado, se
recoge en un pequeño depósito colocado en la
parte posterior sobre el motocompresor del aparato,
de donde evapora.
Se recomienda limpiar periódicamente el agujero
de desagüe del agua de desescarche, situado en
la parte central del canal en el compartimiento
refrigerante, utilizando el «limpiador» adecuado
que se encuentra en el agujero, para evitar que
el agua de desescarche caiga sobre los
alimentos.
D037
39
CUSTOMER SERVICE AND SPARE PARTS
If the appliance is not functioning properly, check
that:
the plug is firmly in the wall socket and the mains
power switch is on;
there is an electricity supply (find out by plugging
in another appliance);
the thermostat knob is in the correct position.
If there are water drops on the bottom of the
cabinet, check that the defrost water drain
opening is not obstructed (see “Defrosting”
section).
If your appliance is still not working properly after
making the above checks, contact the nearest
service centre.
To obtain fast service, it is essential that when you
apply for it you specify the model and serial number
of your appliance which can be found on the
guarantee certificate or on the rating plate located
inside the appliance, on the bottom left-hand side.
TECHNICAL INFORMATION
The technical infomation are situated in the rating plate on the internal left side of the appliance .
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with a plastic scraper , whenever the
thickness of the frost exceeds 4 mm. During this
operation it is not necessary to switch off the power
supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
and it is advisable to carry out this operation when
the appliance is empty.
To carry out complete defrosting of the freezer
compartment proceed as follows:
1. pull out the plug from the wall socket or turn the
thermostat knob to the «O» setting;
2. remove any stored food, wrap it in several layers
of newspaper and put it in a cool place;
3. leave the door open;
4. when defrosting is completed, dry the interior
thoroughly;
5. turn the thermostat knob back to the required
setting or replace the plug in the power socket.
After letting the appliance run for at least half an
hour, replace the previously removed food into
the compartment.
Important:
Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.
Do not use a maechanical device or any artificial
means to speed up the thawing process other
than those recommended by the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe storage
life.
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
ATTENTION!
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.