Operation Manual

48
➡ If ever the sparkers get
dirty, clean them with a stiff
non-metallic brush.
➡ The gas injectors are in the
centre of each burner in the
form of a "pot". Make sure not
to block them up partially when
cleaning the hob, as this will
considerably reduce the perfor-
mance of your gas-rings.
- Should a crack appear on the glass-top, disconnect your
appliance immediately and contact your After-Sales Service.
- It is better to wash the parts of your hob by hand rather than in a dishwasher.
- Never use an abrasive sponge for cleaning your hob.
thermocouple
Nut
Injector
Sparker
ACCESSORIES TO
BE USED
✓ Small hard-bristled brush.
✓ Non-abrasive cream.
✓ Household sponge.
Keeping your hob in good condition is easy if you clean it before it is completely cold.
Even so, never clean it when it is in use. Put all the control knobs at zero.
HOW TO PROCEED
➤➤
Looking after
sparkers and in-
jectors
➡ Use a non-abrasive cream
for removing any persistent
stains. Then rinse with clean
water. Dry each burner ele-
ment carefully before
re-lighting your hob.
➤➤
Looking after
the grills and gas
burners
✓ Household sponge.
✓ Special ceramic glass pro-
ducts E.g. Cera-Clen.
➡ Clean it with hot water, then
wipe dry. Use special ceramic
glass cleaning products for any
persistent stains.
➤➤
Looking after
your glass top
How to look after your hob?
99617431_ML.qxd 14/02/03 14:28 Page 48