Operation Manual

34
Installing your hob in all simplicity
To make sure that nothing can get
between the frame and the worktop,
stick the foam seal around the
outside of the hob.
Affix the joint provided in the folder
before installing the hob :
1- Remove the pan support grates,
the burner caps and heads after
checking their position.
2- Turn the hob over and place it very
carefully over the opening in the unit
taking great care not to damage the
ignition sparkers.
3- Stick the foam seal delivered with
the appliance around the outside of
the hob. This seal prevents anything
getting between the glass and the
worktop.
4- Put the burners, caps and pan
grates back into position.
I
NSTALLATION OVER A UNIT WITH DOORS
OR DRAWERS
(please see the diagram
opposite).
The installation of your hob over an
oven requires that this should be in
the low position.
You are advised not to install your hob
over an oven for which ventilation is
not carried out from the front.
You should leave an air inlet of 40 cm2
in the right or left wall of the oven
unit.
Fitting recommendations (cont'd)
Seal
Mini 4mm
Gas hob
100 mm
mini
Worktop
Mini 40 cm
2
99617431_ML.qxd 14/02/03 14:27 Page 34