User Manual

17
2 / INSTALLING YOUR DISHWASHER
EN
0.90m max
0.4m max
0.30m min
65°C max
1-10 bars
0 - 40 cm
30 cm mini
Fig. 2 - 2
Fig. 2 - 1
You can connect the end of the drain hose to:
- A ventilated U-bend (Fig. 2-1) or
- A sink U-bend (Fig. 2-1)
When connecting to a U-bend, you must remove
the flapper from the U-bend. Then fully install the
rubber end. If necessary, add a tightening collar
.
NB:
Ensure that the drain hose is held in
place with a tie to avoid any potential flooding.
The drain connection must be 0.30m (minimum)
to 0.90m (maximum) above the floor (Fig. 2-1).
The drain hose’s standard length is 1.50m. If
necessary, you can increase the hose’s length
(up to 3m maximum). In this case, check that the
appliance drains correctly. The hose must rest
on the floor and only rise vertically close to the
drainage system.
For appliances installed in vertical units, the
drainage system must not rise higher than the
top of the appliance (Fig. 2-2).
Important:
When fitting the hose, pull on it gradually
so as not to kink it.
..
Avoid any kinks or constrictions in the hose,
which could prevent the water from passing or
slow down its flow.
BB
PP1100
• DRAINING AWAY THE WASTE WATER