EN INSTRUCTIONS FOR USE DWSL980X DWSR980X Wine Cellar LES NOUVEAUX OBJETS DE VALEUR
CONTENTS Safety information Control panel First use Daily use Care and Cleaning 2 4 5 5 7 What to do if… Technical data Installation Environmental concerns 8 10 10 12 Subject to change without notice SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
• • • • 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5. If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire. 6. You must not operate the appliance without the lamp cover1) of interior lighting. This appliance is heavy.
ance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish.
Light button If you would like the light to remain on, with the door closed, it is sufficient to open and close the door and the light will remain ON automatically for 10 minutes. If you want to switch off the light before the automatic turn off time, open the door and push the Light button. The light has no negative effect on the quality on the wine.
• For rose’ and light red wines, between 12 and 16°C • Aged red wines, 14 -16°C When placing various bottles on top of each other, make sure they do not touch the refrigerator cooling plate. The bottom compartment is fitted with a basket useful for placing upright and sloping bottles. Wine Cellar shelves The shelves can be removed for cleaning. Wine Cellar Bottle Holder Remove the shelf and insert it between the two guides. The maximum possible weight on the bottle shelves is 30 kg.
ted in function of the appliance thermostat setting and ambient conditions. Air circulation The refrigerator compartment has a special AIRLIGHT fan which is automatically activa- CARE AND CLEANING Caution! Unplug the appliance before carrying out any maintenance operation. Important! Take care of not to damage the cooling system. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
Periods of non-operation When the appliance is not in use for long periods, take the following precautions: • disconnect the appliance from electricity supply • defrost 4)and clean the appliance and all accessories • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.
Problem Possible cause Solution Water flows on the rear plate of the refrigerator. During the automatic defrosting process, frost defrosts on the rear plate. This is correct. Water flows into the refrigerator. The water outlet is clogged. Clean the water outlet. Products prevent that water flows into the water collector. Make sure that products do not touch the rear plate. The temperature regulator is not set correctly. Set a higher/lower temperature. The door is not closed correctly.
3. If necessary, replace the defective door gaskets. Contact the Service Center. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class min.
2. Install the appliance in the niche. 3. Attach the appliance to the niche with 4 screws. 4. Fix the covers on the screws. Do a final check to make sure that: • All screws are tightened. • The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. Assembly instructions for the compensator lower part of the door 1. With the door open, loosen the two screws situated in the lower part without unscrewing them completely.
2. Position the steel compensator as indicated in the figure and insert the upper part under the head of the screws. 4. Insert the steel carter inside the compensator as indicated in the figure. 3. Align the compensator with the steel door panel and tighten the screws. ENVIRONMENTAL CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste.
Service Consommateurs De Dietrich BP 9526 95069 CERGY PONTOISE CEDEX Tel : +33 (0) 892 02 88 04 *0,34 Eur TTC / min à partir d’un poste fixe • Service fourni par FagorBrandt SAS, locataire-gérant, Etablissement de Cergy, • 5/7 avenue des Béthunes, 95 310 Saint Ouen L’Aumône www.dedietrich-electromenager.
FagorBrandt SAS, locataire-gérant - SAS au capital social de 20 000 000 euros RCS Nanterre 440 303 196.