Operation Manual

7638216-02 - 190620156 KALIKO SPLIT
1 Safety Instructions
Warning
Take precautions with the domestic hot
water. Depending on the settings of the
thermodynamic water heater, the domestic hot
water temperature may exceed 65°C.
Caution
Only genuine spare parts may be used.
Warning
Only qualified persons are authorised to
assemble, install and maintain the installation.
1.2 Recommendations
Note
● The appliance is intended to be permanently
connected to the water mains.
● Maximum / minimum water inlet pressure:
See chapter on Technical Specifications.
● The pressure limiter device must be regularly
operated in order to remove limescale
deposits and ensure that it is not blocked.
● Draining: Shut off the domestic cold water
inlet. Open a hot water tap in the installation
and then open the valve on the safety unit.
When the water stops flowing, the appliance
has been drained.
● A pressure reducer (not provided) is
necessary when the the supply pressure
exceeds 80% of the calibration of the safety
valve or safety unit and it must be located
upstream of the appliance.
● As water may flow out of the discharge pipe
on the pressure limiter device,
the discharge pipe must be kept clear and
open.
● Connect the pressure limiter device to a
drainage pipe, kept open to the air, in a
frost-free environment, and at a continuous
downward gradient.
Caution
Install the domestic hot water tank in a frost-free
environment.
Caution
Do not neglect to service the thermodynamic
water heater. Service the thermodynamic water
heater regularly to ensure that it runs correctly.