Operation Manual

a)Remove any accessories from the oven and wipe off any excess grime.
b ) Check that the programmer displays normal time and that it is not flashing.
c) Press the program selection touch control until the "Pyro-clean" program
appears
Your oven has 3 pyrolysis symbols that correspond to 1 two-hour pyro.
(Non-adjustable).
Y ou can select the two other cycles ( 1h45, or 1h30) non-adjustable, by
pressing the
-
ou +
.
The oven cannot be used for 2h, 2h 15 or 2h 30. These times allow for cooling
down until the door is automatically unlocked.
d ) Press the S TART/STO P touch control.
- The door is locked during pyro-cleaning (after about 2 minutes).
- You can consult the finishing time for the pyro-clean cycle by pressing touch
control .
At the end of pyro-cleaning the symbol remains lit until the door is automatically unlocked.
e) Stop the oven by pressing the S TART/STO P touch control.
f) Use a damp cloth for removing the white ash after the oven has cooled down.
How to use the pyro-clean program Model UMP 50*
HOW TTO UUSE TTHE PPYRO-CCLEAN PPROGRAM
The oven is now ready for use.
Note: The pyro-cleaning temperature cannot be altered. During the cleaning cycle the light is switched of f. If your oven is still
not clean after pyro-cleaning you have delayed cleaning too long. Repeat the pyro-clean program.
IMPORTANT: Do not hang any cloths or towels on the oven door handle.
During the pyro-clean cycle, the front of the oven gets hotter than during normal cooking.
Keep young children away.
How to program your pyro-clean to start when you want Model UMP 50*
Follow the instructions given in the section entitled "How to use the pyro-clean program", then:
a) Press touch control ,the finishing time for the pyro-clean program flashes and the
symbol also flashes to show that this time can be modified.
b) Set the time the program is due to finish by pressing the
+ or
-
touch controls.
Example: End of the pyro-clean program at 5h00.
When the pyro-clean program is over, press the S TART/STO P touch
control.
11