Operation Manual

12
HOW TTO UUSE TTHE PPYRO-CCLEAN PPROGRAM
a)Remove any accessories from the oven and wipe off any excess grime.
b ) Check that the programmer displays normal time and that it is not flashing.
c)Press the program selection touch control until the "Pyro-clean" program
appears.
Your oven displays the pyro-clean symbols and Ctl corresponding to "Pyro
Control".
Y ou can select the another cycle ( 2h) non-changeable, by pressing the
+
touch control.
The ] symbol will then be displayed on your oven together with "Pyr" which
corresponds to the 2h Pyro cycle.
W ith this cycle the oven cannot be used for 2h 30. This time allows for cooling
down until the door automatically unlocks itself.
d ) Press the S TART/STO P touch control.
For Pyro Control the symbol moves.
For Pyro 2h the symbol remains steady.
- The door is locked automatically during pyro-cleaning (after about 2 minutes).
- You can consult the finishing time for the pyro-clean cycle by pressing touch control (Only for the Pyro 2h cycle).
After pyro-cleaning the symbol remains lit until the door is automatically unlocked.
e) Stop the oven by pressing the S TART/STO P touch control.
f) After the oven has cooled down, use a damp cloth for removing the white ash.
The oven is now ready for use.
Note: The pyro-cleaning temperature cannot be altered. During the cleaning cycle the lighting is switched of f. If your oven is
still not clean after pyro-cleaning you have delayed cleaning too long. Repeat the operation.
IMPORTANT: Do not hang any cloths or towels on the oven door handle.
During the pyro-clean operation, the front of the oven gets hotter than during normal cooking.
Keep children away.
how to use the pyro-clean program Model UMP 51*
How to program your pyro-clean to start when you want Model UMP 51*
Follow the instructions given in the section entitled "How to use the pyro-clean program", then:
1) For "Pyro Control":
a) Press touch control , the starting time of the pyro-clean program
flashes and the symbol also flashes to show that this time can be modified.
b) Set the time the program is due to start by pressing the
+ or
-
touch
controls.
Example: Begin the pyro-clean program at 5 am (05:00)
When the pyro-clean program is over press the S TART/STO P touch control.
NOTE : As the duration of the pyro-clean cycle is calculated during the cycle itself, depending on the state of the oven, you
can only adjust the time at which the cycle starts.
2) For the 2 hour Pyro:
a) Press touch control , the finishing time for the pyro-clean
program flashes and the symbol also flashes to show that this time can be
modified.
b) Set the time the program is due to finish by pressing the
+or
-
touch controls.
Example: End of pyro-clean program at 5:00.
When the pyro-clean program is over press the
START/STO P touch control.