IMPORTANT INSTRUCTIONS SAVE THESE INSTRUCTIONS INSTRUCIONES IMPORTANTES GUARDE ESTAS INSTRUCCIONES ELECTRIC CONVECTOR HEATER TERMOCONVECTOR ELECTRICO 1
IMPORTANT SAFEGUARDS When using electrical appliances, basic precautions should always be followed to reduce risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handle when moving this heater.
heater. Plugging heater into a worn outlet /receptacle/ may result in overheating of the power cord or fire. 17. Do not use an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be Ul listed No. 1 4 AWG minimum size and rated not less than 1 875 watts, ISAMP at 125 V and has to be used only for supplying power to this heater. 18. Be sure that the plug is fully inserted into an appropriate receptacle.
HOW TO USE YOUR HEATER FEET ASSEMBLING Remove the feet from the packing. Fit the feet to the appliance as follows: 1 Insert the anchor pins (A) into the slots and turn the foot until it clicks into position (fig. 1). 2 Fasten the feet in position using the screw (fig. 2). A fig. 1 fig. 2 BE CAREFUL Operate the heater in upright position only. Any other position could create hazard situation! The appliance is fitted with a tilt-swich which turns the appliance off if it should fall over.
further. Keep thermostat at this setting for future use. When temperature drops below your selected temperature, the heater switches on automatically until the room again reaches the set temperature. Room comfort is thus maintained with minimum use of electricity. MODEL WITH FAN Proceed as follows: - as warm ventilation during cold months, by pushing on the fan switch (see figure), along with one or both switches. Your fan will propel the heat instantly.