5714810131/05.
Dehumidifier
Experts have established that the optimum environmental conditions for our well being and for the home are obtained between 40% and 60% relative humidity. With very low temperatures, you are recommended to heat the room even minimally. This considerably increases the dehumidifying power of the appliance. With heating, the condensation formed by the water vapour on windows and other cold surfaces evaporates into the air to be collected by the dehumidifier.
INTRODUCTION SAFETY Thank you for choosing this De’Longhi dehumidifier. To get the best results, please read these instructions carefully before use. Fundamental safety warnings Danger! This is an electrical appliance, it is therefore important to respect the following safety warnings: • Do not touch the appliance with wet hands. This may cause damage. • Do not touch the plug with wet hands. • Make sure the mains socket used is always accessible, enabling you to unplug the appliance when necessary.
Appropriate use Instructions The appliance is designed and produced for domestic use only. Use this appliance only as described in this instruction manual. As with all electrical equipment, whilst the instructions aim to cover as many eventualities as possible. Caution and common sense should be applied when operating and installing this appliance. Read these instructions carefully before installing and/or using the appliance. • Keep these instructions carefully.
INSTALLATION Position the appliance in the room to be dehumidified. A free space of at least 50 cm must be left at the front of the dehumidifier, so as not to block the air outlet. For efficient ventilation a space of about 5-10 cm should be left at the back of the appliance. The condensate can be drained in one of the following ways: Please Note: Keep the rubber bung to close the spout. fig. 3 NO A) Draining into the tank The condensate can be drained directly into the tank.
HOW TO DEHUMIDIFY Tank full/tank absent light Dehumidifying standby/freeze protection light Humidistat dial How to dehumidify Dry mode (drying washing) • Plug the appliance into a mains socket. • Make sure the "tank full/tank missing" light is off. If it is on, position the tank correctly. • The dehumidifying standby light comes on during the first three minutes (safety device), then the appliance starts dehumidifying.
INDICATOR LIGHTS Dehumidifying standby/low-temperature operation light Tank control system light The light comes on: This dehumidifier has a special device to control correct operation. A red indicator light on the control panel comes on to warn the user when: 1) To indicate the appliance is in standby for about three minutes before start-up. This device protects the compressor from starting and stopping too often. 2) To indicate low temperature operation.
CLEANING AND MAINTENANCE particles, but also has an efficient antibacterial action. It also greatly reduces concentrations of irritants such as pollen and spores. The filter is treated with small particles of silver (on the scale of millionths of a millimetre) which are able to block the multiplication of and destroy any bacteria or spores coming into contact with them. Always unplug the appliance from the power socket before performing any cleaning or maintenance operations.
TROUBLESHOOTING Check the following points before calling your local authorised Service Centre. PROBLEMS The appliance is operating in dehumidifying mode, but the humidity does not decrease. CAUSE SOLUTION The filter is blocked. Clean the filter. The temperature or humidity in the room is too low. In certain conditions, it is normal for the appliance not to dehumidify (in certain cases, it is recommended to heat the environment). The room is too big for the dehumidifying power of the appliance.
