Fryer User Manual

HIGH EFFICIENCY DECATHLON SERIES GAS FRYERS

CHAPTER 1: SERVICE PROCEDURES

1-21

1.7.7 Replacing the Frypot (cont.)

6. Remove the top cap. It is held in place by one screw on

each side of the fryer. If the fryer has a controller on

the front, the top cap may also be held in place by two

screws on the front of each pot. FPHD65 units may

have two screws on each end of the top cap.

7. Remove the joiner strips on either side of the frypot. Be

careful not to bend the joiner strip during removal.

8. Remove back panels of the fryer.

There may be both upper and lower

panels and several screws secure

them. Screw location and orientation

will vary according to fryer model.

9. Remove screw securing brace (and back panel) to the

flue cap. Support the brace with hand while removing

screw to prevent brace from falling away. Remove

brace and set aside for reassembly.

Typical screw locations on the back panel (may vary by

model).

Removing brace holding back panel to flue

cap.

Removin

the

oiner stri