Data Sheet

Page 16 of 16
DEASINO
his transmitter/module and its antenna(s) must not be co-located or operating in conjunction
with any transmitter. This information also extends to the host manufacturer’s instruction
manual.
2.4 Limited module procedures
not applicable.
2.5 Trace antenna designs
It is “not applicable” as trace antenna which is not used on the module.
2.6 RF exposure considerations
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This compliance to FCC radiation exposure limits for an uncontrolled environment,
and minimum of 5mm separation between antenna and body.
The host product manufacturer would provide the above information to end users in their
end-product manuals.
2.7 Antennas
PCB antenna; 0dBi;2.402 GHz～2.480GHz.
2.8 Label and compliance information
The end product must carry a physical label or shall use e-labeling followed KDB784748D01 and
KDB 784748 stating “Contains Transmitter Module FCC ID: 2AV9TDS-52810-01”.
2.9 Information on test modes and additional testing requirements
please enter your text here
Programming “ direct test mode software “ and use TI “Nordic nRFgo studio” driver to control
fixed frequency for testing requirements. And programming application software for radiate test.
2.10 Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.247) listed
on the grant, and that the host product manufacturer is responsible for compliance to any other
FCC rules that apply to the host not covered by the modular transmitter grant of certification. The
final host product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed when contains digital circuity.