User's Manual

10
1. Quick Start
Use the following instructions to quick start your G3™:
1. With all cables and antennas attached, plug the cigar plug of
the radar into a powered 12VDC cigarette lighter receptacle
in the patrol vehicle.
2. Press the PWR button on the front display to power up the radar
unit. The radar will run through a brief self-test which includes
illuminating all display segments.
3. Press the ANT FRONT or REAR button to select the antenna from
which you want the radar to transmit. Press the same ANT button
when you wish to place the radar back into standby mode.
4. Press and release the MODE button to quickly toggle between
Moving Mode Opposite Direction and Moving Mode Same
Direction. Press and hold the MODE button for two seconds to
activate Stationary Mode.
5. Press and hold the FAST button to select Faster Mode when you
want to track the next strongest target going faster than the
strongest.
6. In Moving Mode Same Direction setting G3 and its directional
antenna will automatically perform addition or subtraction
relative to the patrol speed to properly calculate the target
speeds.
7. To lock a target speed, press the LOCK button. The target speed
and its direction information will transfer to the LOCKED window
and locked direction indicators. The radar will continue to
process speeds and display them in the TARGET window.
8. To clear a locked speed, press the LOCK button when an antenna
is transmitting, and no target is present.
G3™ Users & Installation Manual