User's Manual

14
You can mount the computer/display unit behind and to the side of
the steering wheel or on the dashboard. The computer unit easily
withstands and remains accurate in temperature extremes. Dash-
mounting the unit promotes safety; you can read the display without
taking your eyes off the road.
To mount the unit, use the Velcro™ fastening material or the
mounting bracket. Before applying the Velcro™, use a clean cloth to
remove any foreign material from the dashboard and bracket face.
Position the Velcro™ lightly on the computer/display unit and
mounting surface.
After the unit is in the correct position, press it firmly to affix it to the
surface. For the bracket mount, simply place and tighten the screws
on the mounting bracket into the holes in the unit. Then adhere
the suction cups to a clean glass surface. For maximum adhesion,
moisten the suction cups before affixing them to the surface.
There are four locations where cables connect to the rear panel of
the computer unit. Two are quick-disconnect Ethernet connectors
for the antennas, a third is a nine pin DB-9 connector and the last is a
quick disconnect power connector.
Figure 2.2a
The antenna quick-disconnect connectors
plug into the computer unit in the above
locations.
G3 ™ User & Installation Manual