User's Manual

22
If the LED is on and the VIP™ is connected to a radar unit, then
when the radar is turned on and it runs through its diagnostics
routine it will show the message “VIP” as the last message on power
up.
Once the power-up routine has run correctly and the VIP™ message
has been displayed, the next step is to make sure the G3 computer
is configured properly. To do this have the vehicle running but
stopped. With the VIP™ properly installed try to put the radar into
moving mode. The VIP™ should note that the vehicle is stopped and
automatically switch the radar to stationary mode.
The next step will walk you through setting up the VIP™ if it is not
being recognized by the radar. You can also refer to the menu feature
set up in the radar’s operator manual.
2.5.4 Configuring the VIP™
To get the G3™ to recognize that the VIP™ has been connected it
may be necessary to go into the radar’s menu feature and select the
VIP™.
1. With the radar turned on and all power-up routines having been
ran, press the MENU button on the IR remote.
2. Next, press the OPTION button several times until VIP™ is displayed in the
locked/fast window.
3. Press the UP arrow (front antenna) or down arrow (rear antenna)
button and make sure the word AUT is showing in the patrol
display.
4. Press the MENU button again to exit the menu and save the setting.
• If your radar does not automatically switch to stationary
mode when stopped, please check the menu feature
setup on the radar and make sure the VIP™ has been
activated.
G3™ User & Installation Manual