How-To Guide

STEP 2
Select silicone tip size
Choose the silicone tips that will fit you best and securely
place them onto the custom earpieces. Check to make sure
the silicone tips are securely attached. ONLY PLACE THE
CUSTOM MOLDS AND THE MOLDING TOOL INTO THE WATER.
DO NOT PLACE EARPHONES INTO THE WATER!
STEP 3
Place custom molds on molding tool
Assemble molding tool as shown. Test the molding tool to
make sure it fits into your container and sits flat on the base.
Place custom molds on the molding tool making sure the left and
right earpieces are on the left and right side of the molding tool.
STEP 4
Heat water to a boil
Boil 3 inches of water, remove from the heat source if needed. Slowly insert
the molding tool and earpieces into the hot water. Let sit for 5 minutes.
STEP 5
Preparing to mold the earpieces
Carefully remove the molding tool and molds from the hot water and
remove one of the custom molds. Place the tool and remaining
earpiece back in the water. Wait 30 seconds for the earpiece, that you
have just removed from the molding tool, to cool.
STEP 7
Snap in the earphones
Once the earpieces have cooled for 4 minutes, remove them from your
ears and snap in the earphones. Make sure the right earphone goes
into the right earpiece and the left earphone goes into the left earpiece.
STEP 6
Molding the earpieces
Be sure the “R” custom mold goes in your right ear. The silicone tip
should be towards the bottom. Now firmly press the earpiece into
your ear. You may need to press and smooth the molding material
slightly for a cleaner appearance. Now leave the earpiece in your ear
for 4 minutes. Repeat the process for the other ear.
Note: You will not feel an acoustic seal until the
earphones are inserted in the next step.
For the best results, watch
our instructional video at
www.decibullz.com/truewireless
STEP 1
Charge the case and earphones
Place the earphones into the charging case and fully charge earphones and
charging case before setting up. The left earphone will only charge in the
left cavity and vice versa. The "L" & "R" on the charging case will light up
while the earphones are charging. If the Custom Molded Earpieces are
attached to the earphones remove them at this time.
CAUTION: DO NOT PLACE
THE MOLD INTO EAR WHILE IT
IS HOT! WAIT UNTIL THE
MOLD IS WARM AND PLIABLE.
TIP Using a mirror can make the process easier.
CAUTION:
WATER AND
OTHER ITEMS WILL
BE VERY HOT.
Place both earphones back into the charging case and
follow pairing and use instructions on the next page.
HOW TO MOLD
REMOLDING
If you do not feel an acoustic seal after molding try various sizes and
combinations of canal tips before re-molding. If for any reason you would
like to re-shape your earpieces simply unsnap the earphones from the
custom molds by using the notches to gently release the earphones.
Then repeat steps 2-6.
To separate the custom mold from the earphone, place your thumb and
finger on the notches at the top and bottom of the earphone and gently pull.
USB-C
CABLE
START HERE
Please review these instructions first to familiarize
yourself with the molding process.
3in of Water.
The top of the molding
tool should remain
above the water for
safe removal.