Use and Care Manual

SOLAR TIKI TORCH LIGHT
Use and Care
Guide
TOOLS REQUIRED
PACKAGE CONTENTS
Phillips Screwdriver
A – Lamp Body x 6
B – Lamp Pole x 6
C – Ground Stake x 6
D – Battery x 6
Installation & Operation
Installing the light
□ Insert the ground stake (C) firmly into the ground at the installation
location. If the ground is too hard, soak the ground with water to soften the
ground or drive a metal rod or screwdriver into the ground to create a hole
for the ground stake (C).
□ Connect the lamp pole (B) to the ground stake (C).
□ Connect the lamp body assembly (A) to the lamp pole (B).
IMPORTANT: Ensure the mounting location for your solar light allows
the solar panel to receive direct sunlight. Do not locate the product in
shaded areas as this will significantly reduce performance.
NOTE: The solar light is equipped with a photosensor that turns the
unit on at dusk and off at dawn. Ambient light can affect the operation
of the photosensor.
NOTE: Do not use a hammer. If the ground is hard, use water to
soften.
Operating the light
□ Hold the lamp housing (Ac) and rotate the top cap (Aa) counterclockwise
until it is loose. Then, remove the top cap and the light diffuser assembly
(Aa & Ab) from the lamp housing (Ac).
□ Rotate the light diffuser (Ab) clockwise until it is loose. Then, remove the
light diffuser (Ab) from the top cap (Aa).
□ Your solar light is equipped with an ON/OFF switch on the back plate of
the top cap (Aa), the switch must be set to ON position prior to use.
□ After you set the switch to ON, replace the top cap (Aa) and the light
diffuser (Ab) back to the lamp housing (Ac) and allow it to charge for a full
sunny day.
Safety Information
WARNING: Your solar light may not function in temperatures
below -4ºF (-20ºC) or above 140ºF (60ºC).
CAUTION: Use a rechargeable battery only. Recycle or dispose
of batteries properly.
CAUTION: Do not open, short circuit, or mutilate batteries as
injury may occur.